April 17, 2018 at 3:18PM
3d lut in Davinci Resolve
Can you adjust the amount of a lut in Resolve the same way you can in Premiere? I'm trying to learn Resolve but can't seem to figure how to dial in the amount of an applied 3d lut. I know you can control a lot of other parameters just wondering if there is an easy way to do this. Thanks in advance!
4 Comments
Found a method, in case anyone else is curious... https://lutify.me/support/documentation/how-can-i-change-the-strengthopa...
April 17, 2018 at 3:25PM
They way I do it is after adding your LUT to a node just adjust the key output. Anything less than one will reduce it's strength.
April 18, 2018 at 9:11AM, Edited April 18, 9:11AM
there is many way to do that, you can change the opacity of node, you can stack a layer node that allow you to blend in different way the lut effect, you can do a qualifier to apply a lut only in a part of picture, and so on... Resolve had tons of tools and solution to do everything you can think about color, and more :-D
April 18, 2018 at 1:34PM
But yeah, the simplest way I know is to go to the Key panel and adjust the Gain, I believe it is, to something like .9, .8 etc. Basically just changing how strong the node/LUT is.
April 20, 2018 at 1:43AM
Your Comment